Family business established 1984 · Independent appliance repairsEngineer visits Monday to Thursday

Washer dryers · Crystal Palace

Washer dryer repairs in Crystal Palace

A washer dryer does two jobs in one drum, so a fault can affect washing, drying or both. We repair washer dryers from all the main brands across Crystal Palace and nearby.

Washer dryer in a kitchen

Washer dryers share their pump, motor and door lock between the wash and the dry. The drying side adds a heater, a fan and a condensing system that uses cold water to remove moisture from the air.

Tell us whether the problem appears while washing, while drying or both. That one detail points our engineer to the right part of the machine before they arrive.

Common washer dryer faults we fix

Washes but won't dry

A failed drying heater, thermostat or fan motor leaves clothes hot and damp or cold and wet.

Clothes come out damp

Overloading the drying cycle is the usual culprit, followed by a blocked condenser channel.

Won't drain

A blocked filter or pump stops both the wash and the condensing water from draining.

Burning smell when drying

Fluff build-up on the heater or fan should be checked straight away. Stop using the dryer function.

Door stays locked

The lock waits for the drum to cool after drying. If it never releases, the lock or sensor may have failed.

Leaking during drying

Condensing water can leak if the internal drain route is blocked.

Error codes

Many washer dryers show separate codes for wash and dry faults. Note the exact code.

Noisy spin

Bearings and suspension wear just as they do in washing machines.

Takes hours to dry

Heaters cycling on and off too often can point to a thermostat or sensor fault.

Won't start

Door lock, power supply and control board faults all stop the programme beginning.

Quick checks before you call

  • Dry no more than about half the washing load at a time; check your manual for the exact drying capacity.
  • Clean the drain filter, since the dryer also drains through it.
  • Make sure the water tap is on, as many models use water to condense steam while drying.
  • Note whether the fault happens on washing, drying or both.

When to stop using it

Stop using the drying function if you notice a burning smell, scorched clothes or the outside of the machine becoming very hot.

Where to find the model number

Inside the door frame around the porthole, or on the back panel.

Washer dryer brands we repair

Washer dryer repairs near Crystal Palace

Washer dryer fault guides

All washer dryer guides

Questions customers ask

Why do clothes take so long to dry?

Washer dryers dry smaller loads than they wash. If small loads are still damp after a full cycle, the heater, thermostat or condenser needs checking.

Can you fix just the drying part?

Yes. Drying faults are often separate parts such as the heater or fan, so the washing side keeps working.

Do you work on integrated washer dryers?

Yes. Mention it when you book so we can allow for removing the unit from its housing.

Which areas do you cover?

Crystal Palace, Upper Norwood, Gipsy Hill, Anerley, Penge, Sydenham, South Norwood, West Norwood, Beckenham, Dulwich and Forest Hill.

Book your repair

Tell us the make, model and what it’s doing. We’ll explain the next step and the cost before any work starts.

CallBookFault help